Thermal fusion welding of multi-strand enameled wires and motor stator wires

1. No need to paint in advance, no need to weld;

2. During the welding process of the copper terminals, the resistance of the welding part is low;
3. The welding strength is much higher than other "welding processes";
4. This method of soldering makes it impossible to pull the magnet wire out of the "terminal";
5. Through this welding method, the cost is low, and there is no cost of other consumables;
6. Can accurately control the current output;
7. The operator only needs to carry out very simple training, and the operator only needs to start the machine and select the parameters;
8. The production efficiency is fast, and it only takes a few seconds to complete;
Welding test method of electromagnet wire of motor stator copper tube: 1. Test the conductivity of enameled wire. 2. Test resistivity; resistivity should not be higher than the enterprise standard. 3. Check the degree of welding. At the begiing of the peeling, you can clearly see that each enameled Custom Electromagnetic wires  wire is clearly packaged from the enameled wire. Sawed down the middle of the terminal, and it was clear that there was almost no gap between the enameled wires. Fourth, test the tension. 5. Check the appearance of the terminal. No part of the terminal can be melted.
Conclusion of stator copper tube magnet wire welding: This welding process has been applied by a large number of companies at home and abroad, and has been used for many years. Copper tube electromagnetic wire welding effectively improves the consistency and quality of products; copper tube electromagnetic wire welding effectively simplifies the production process; copper tube electromagnetic wire welding also effectively improves the safety and environmental protection issues in the production process; directly and effectively reduces labor, training, installation, maintenance, etc.